Rockwell Automation MagneMotion QuickStick HT User Manual

Introduction
QuickStick HT Transport System Overview
32 MagneMotion
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
QSHT Transport System Components
Figure 1-1: Detailed View of QuickStick HT Transport System Components
• Track System – The components that physically support and move vehicles, includ-
ing the support structure, the guideway, one or more QuickStick HT motors, and
mounting hardware.
• Guideway – Used to make sure that the vehicles are maintained in the proper relation-
ship to the motors.
• Straight and Curve – Motors placed end-to-end to provide a continuous path
of motion.
• Switch – (not shown) Three motors that are configured to provide either a
merge of two paths into one or one path that diverges into two.
• Motor – The QSHT linear synchronous motor (LSM).
• Motor Drive – The remote QSMC motor controller or QSHT 5700 inverter.
• Power Connectors – Provides the connections for logic and propulsion power.
• Communications Connectors – Used for motor to motor communications
and for motor drive to node controller communications at path ends.
• RS-422 – 4-wire serial data transmission protocol for point-to-point
connections that uses differential signals to provide noise resistance.
Guideway
Motor Mount
Vehicle
Motor
Track System
Magnet Array
(not visible)
QSHT 5700 Inverter
QSMC Motor Controller

Rockwell Automation MagneMotion QuickStick HT Specifications

General

Brand	Rockwell Automation
Model	MagneMotion QuickStick HT
Category	Accessories
Language	English