Maintenance
Troubleshooting
286 MagneMotion
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
Troubleshooting
This section describes the common difficulties that are encountered with the QuickStick HT
transport system and software components.
For assistance, see Contact ICT Customer Support on page 300.
Initial Troubleshooting
This section covers the initial determination of the problem area within the QuickStick HT
transport system and provides direction to the second step of the troubleshooting process. If a
specific problem is suspected, see that problem in Table 8-2. If the problem has not been iden-
tified, review each of the symptoms that are identified in Table 8-2 to help determine the prob-
lem area.
Table 8-2: Initial Troubleshooting
Symptom Possible Problem Area
Power lights do not turn on. See Power-Related Troubleshooting on page 287
Motors report power-related faults.
Vehicles do not seem to move as fast as when
the QSHT transport system was initially
installed.
See Power-Related Troubleshooting on page 287
See Motion Control Troubleshooting on page 294
Node controller logs do not indicate the correct
time.
See Node Controller Troubleshooting on page 292
The QSHT transport system does not respond
to the host controller.
See Communication Troubleshooting on page 293
See Motion Control Troubleshooting on page 294
Vehicles are producing excessive noise. See Motion Control Troubleshooting on page 294
The light stack does not function as expected. See Light Stack Troubleshooting on page 295
Changes to motor status returned by PLC. See QSHT 5700 Inverter Fault Troubleshooting on
page 296
To Next Page
Loading...
Need help?
General
