Safety Guidelines
Recycling and Disposal Information
54 MagneMotion
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
Recycling and Disposal Information
Information regarding disposal and recycling are provided in this section. The modules
of the QuickStick HT transport system use the following items that require special han-
dling for disposal or recycling. At the end of its life, this equipment must be collected
separately from any unsorted municipal waste and disposed of as described in this sec-
tion.
For China RoHS information, see https://literature.rockwellautomation.com/idc/
groups/literature/documents/td/pec-td003_-en-e.pdf and reference Table B.
QuickStick HT Transport System
No hazardous materials, other than the materials identified in this section, are used in the
QuickStick HT components. The following items require special handling for disposal or
recycling.
Motor Stators
The stators contain the following materials and must be disposed of by following all facility,
local, and national procedures for the disposal of electronic equipment:
• Aluminum alloy with chromate over cadmium plating.
• Stainless steel.
• Rubber.
• Nickel plated brass.
• Circuit board with connectors and semiconductors.
• Oxy-Cast 607 epoxy.
QSMC Motor Controllers
The motor controllers contain the following materials and must be disposed of by following
all facility, local, and national procedures for the disposal of electronic equipment:
• Anodized Aluminum.
• Circuit board with connectors and semiconductors.
• Zinc-plated Low Carbon Steel Screws.
To Next Page
Loading...
Need help?
General
