Suzuki drz 400 2007 User Manual

5- 12 COOLING SYSTEM
• Slowly
heat the container and check the temperature on the
thermometer when the thermostat
valve begins to open.
_ Thermostat valve opening temperature:
Approximately 75°C (167"F)
•
Continue heating the container until the water temperature is
above lJU "C (H/4 " /-) .
• When the water temperature reaches 90 °C (1 94° F) , the ther-
mostat
valve should have lifted at least 6.0 mm (0 .24 in).
~ Thermostat valve lift : over 6.0 mm at 90°C
(over 0.24 in at 194°F)
•
If the thermostat is faulty in either of these two checks, re-
place it.
INSTALLATION
• I ns tall the thermostat in the reverse OllJt:.:r ur '~rIlUVi:11. Pay at-
tention to the following points.
• Apply SUZUKI SUPER GREASE "A" to the rubber seal on
th e thermostat.
For
USA
~ 99000-25030: SUZUKI SUPER GREASE "A"
For the other countries
~ 99000-25010: SUZUKI SUPER GREASE "A"
•
After installing the thermostat, be sure to add engine coolant.
(C:7' 2-15)
6.0 mm --=~~~ 1 t:;;5 lpj
(0.24 in ) "::I
http://www.motorcycle.in.th

Suzuki drz 400 2007 Specifications

General

Year	2007
Manufacturer	Suzuki
Model	DR-Z400
Category	Dual-sport
Displacement	398 cc
Bore x Stroke	90.0 mm x 62.6 mm
Compression Ratio	11.3:1
Transmission	5-speed
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Front Brakes	Single disc
Rear Brakes	Single disc
Front Tire	80/100-21
Rear Tire	120/90-18
Seat Height	935 mm (36.8 in)
Fuel System	Mikuni BSR36 carburetor
Ignition	CDI
Rear Suspension	Link type, coil spring, oil damped
Ground Clearance	300 mm
Wheelbase	1, 485 mm
Fuel Capacity	10.0 L (2.6 US gal)
Engine Type	Single-cylinder, four-stroke