Suzuki drz 400 2007 User Manual

BEARINGS
Wash the bearing with a cleaning solvent and lubricate it with
motor
oil before inspection. Rotate the inner race and check to
see that
it turns smoothly. If it does not turn quietly and smoothly,
or if there are signs of any abnormalities, the bearing is defec-
tive and must be replaced with a new one as follows.
RIGHT COUNTERSHAFT BEARING
•
Remove the bearing retainer.
• Remove the right countershaft bearing using the special tool.
S 09921-20220: Bearing remover set
A CAUTION I
Replace the removed bearing with a new one .
• Install the right countershaft bearings using the special tool.
S 09913-70210: Bearing installer set
• Apply a small quantity of THREAD LOCK "1342" or THREAD
LOCK SUPER " 1322 " to tho boaring retainer screws, and
tighten them securely.
For USA
~ 99000-32050: THREAD LOCK " 1342"
For the other countries
= 99000-32110: THREAD LOCK SUPER " 1322"
LEFT COUNTERSHAFT BEARING
• Remove the left countershaft bearing using the special tool.
SJ 09923-73210: Bearing remover
09930-30102: Sliding hammer
I ACAUT }ON]
Replace the removed bearing with a new one .
• Install the left countershaft bearing using the special tool.
!iii 09913-70210: Bearing installer set
ENGINE 3-43
P lay
=:If-
I
101
1.1 , Play
- -
J( lJ
11
http://www.motorcycle.in.th

Suzuki drz 400 2007 Specifications

General

Year	2007
Manufacturer	Suzuki
Model	DR-Z400
Category	Dual-sport
Displacement	398 cc
Bore x Stroke	90.0 mm x 62.6 mm
Compression Ratio	11.3:1
Transmission	5-speed
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Front Brakes	Single disc
Rear Brakes	Single disc
Front Tire	80/100-21
Rear Tire	120/90-18
Seat Height	935 mm (36.8 in)
Fuel System	Mikuni BSR36 carburetor
Ignition	CDI
Rear Suspension	Link type, coil spring, oil damped
Ground Clearance	300 mm
Wheelbase	1, 485 mm
Fuel Capacity	10.0 L (2.6 US gal)
Engine Type	Single-cylinder, four-stroke