Utilities E-mail o n Event Control Window
Behavior
This window is mainly intended for service personnel. The diagnostic information can be used as part of
an incoming inspection or to diagnose potential problems with the instrument.
NOTE. Remove the input signals before running any diagnostics.
If any diagnostic failures occur, record the failure information, and then contact your local Tektronix
service personnel for more information.
E-mail on Event Control Window
From the Utilities menu, highlight E-mail on Event; then select Setup.
Overview
Use this control window to set up the conditions under which the instrument w ill send an e-mail, the types
of attachments to include, and the message limits.
To use
1. In the Recipient e-mail address(es) entry box, type in the addresses where you want to send e-mail.
Use a comma to separate multiple addresses.
2. In the Send E-mail on check boxes, se lect the events on which you want to send e-mail.
3. Use the E-mail Attachments check boxes to select the type of attachment to include with the e-mail.
4. Click the Settings button to open t he Save Options dialog box and set the parameters for the attachment.
5. In the Limit text box, enter the number o f e-mail m essages to send, up to a maximum of 32767.
552 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
