Tektronix Keithley 4200A-SCS User Manual

In this section:
Micromanipulator 8860 prober software ................................. 10-1
Probe station configuration..................................................... 10-2
Probesites Clarius project example ...................................... 10-18
Probesubsites Clarius project example ................................ 10-23
Commands and error symbols ............................................. 10-28
Micromanipulator 8860 prober software
You need to have the following software programs on the Micromanipulator 8860 to configure and
operate the 8860 prober with the Keithley Instruments 4200A-SCS:
• pcBridge: Used to configure the communications setup (icon on the desktop)
• pcLaunch: Used to launch various wafer controls and utilities (icon on the desktop)
• pcIndie: Used to probe multi-subsites per die (button in pcLaunch window)
• pcWafer: Used to probe single subsites per die (button in pcLaunch window)
• pcNav
• pcRouter
pcIndie and pcWafer, which are not included with standard prober software, are required. Refer to
the prober manufacturer, Micromanipulator, for availability.
Software versions
The following list contains the software versions used to verify the configuration of the 8860 prober
with the 4200A-SCS:
Product Name:
pcBridge
Product Version:
2.0.2
Product Name:
pcIndie
Product Version:
2.0.7
Product Name:
pcLaunch
Product Version:
2.0.9
Section 10
Using a Micromanipulator 8860 Prober

Tektronix Keithley 4200A-SCS Specifications

General

Brand	Tektronix
Model	Keithley 4200A-SCS
Category	Measuring Instruments
Language	English