Tektronix Keithley 4200A-SCS User Manual

Section 4: Using a Model 590 C-V Analyzer Model 4200A-SCS Prober and External Instrument Control
4-6 4200A-913-01 Rev. A December 2020
Model 590 test examples
The test examples for the Model 590 C-V Analyzer are controlled by user test modules (UTMs) in the
ivcvswitch project. The following figure shows the tree for the project.
A switch matrix is not used for these examples.
Figure 51: Project tree when ivcvswitch project is selected
Cable compensation example
This example assumes that the 590 is connected directly to the DUT. The DUT could be a device
installed in a test fixture or a MOS capacitor on a wafer.
The user modules for cable compensation must share the same file for capacitance source values.
Therefore, the same file directory path must be used in all three user modules. For this example, use
the default file directory path (see line 1 of the parameter list in the following figures).

Tektronix Keithley 4200A-SCS Specifications

General

Brand	Tektronix
Model	Keithley 4200A-SCS
Category	Measuring Instruments
Language	English