Accessing
Software Safety
Settings
Safety Settings are password protected and can only be configured once a password is
set and subsequently used.
To access the software safety settings
1. In your PolyScope header, tap the Installation icon.
2. In the Side Menu on the left of the screen, tap Safety.
3. Observe that the Robot Limits screen displays, but settings are inaccessible.
4. If a Safety password was previously set, enter the password and press Unlock
to make settings accessible. Note: Once Safety settings are unlocked, all
settings are now active.
5. Press Lock tab or navigate away from the Safety menu to lock all Safety item
settings again.
You can find more safety system information in the Hardware Installation
Manual.
UR10e 138 User Manual
17.Software Safety Configuration
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
