2.1. Validity and Responsibility
Description The information in this manual does not cover designing, installing and operating a
complete robot application, nor does it cover all peripheral equipment that can
influence the safety of the complete system. The complete system must be designed
and installed in accordance with the safety requirements set forth in the standards and
regulations of the country where the robot is installed.
The integrators of Universal Robots e-Series robots are responsible for ensuring that
the applicable safety laws and regulations in the country concerned are observed and
that any significant hazards in the complete robot application are eliminated. This
includes, but is not limited to:
•
Performing a risk assessment for the complete robot system
•
Interfacing other machines and additional safety devices if defined by the risk
assessment
•
Setting up the appropriate safety settings in the software
•
Ensuring that the user will not modify any safety measures
•
Validating that the total robot system is designed and installed correctly
•
Specifying instructions for use
•
Marking the robot installation with relevant signs and contact information of the
integrator
•
Collecting all documentation in a technical file; including the risk assessment
and this manual
2.2. Limitation of Liability
Description Any safety information provided in this manual must not be construed as a warranty,
by UR, that the industrial manipulator will not cause injury or damage, even if industrial
manipulator complies with all safety instructions.
User Manual 17 UR10e
2.Safety
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
