To connect the Ethernet cable by passing it through the hole at the base of the Control
Box, and plugging it into the Ethernet port on the underside of the bracket.
Replace the cap at the base of the Control Box with an appropriate cable gland to
connect the cable to the Ethernet port.
The electrical specifications are shown in the table below.
Parameter Min Typ Max Unit
Communication speed 10 - 1000 Mb/s
4.10. Mains Connections
Description The mains cable from the Control Box has a standard IEC plug at the end.
Connect a country specific mains plug, or cable, to the IEC plug.
NOTICE
•
IEC 61000-6-4:Chapter 1 scope: “This part of IEC 61000
for emission requirement applies to electrical and
electronic equipment intended for use within the
environment of existing at industrial (see 3.1.12)
locations.”
•
IEC 61000-6-4:Chapter 3.1.12 industrial location:
“Locations characterized by a separate power network,
supplied from a high- or medium-voltage transformer,
dedicated for the supply of the installation”
User Manual 61 UR10e
4. Electrical Interface
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
