Recovery When a safety limit is exceeded, the safety system must be restarted. For example, if a
joint position limit is outside a safety limit, at start-up, Recovery is activated.
You cannot run programs for the robot when recovery is activated, but the robot arm
can be manually moved back within limits using Freedrive, or by using the Move tab in
PolyScope. (see Part II PolyScope Manual)
The safety limits for Recovery are:
Safety Function Limit
Joint Speed Limit 30°/s
Speed Limit 250mm/s
Force Limit 100N
Momentum Limit 10kg m/s
Power Limit 80W
The safety system issues a Stop Category 0 if a violation of these limits appears.
WARNING
Failure to use caution when moving the robot arm in recovery can lead
to hazardous situations.
•
Use caution when moving the robot arm back within the limits,
as limits for the joint positions, the safety planes, and the
tool/end effector orientation are all disabled in recovery.
UR10e 36 User Manual
2.Safety
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
