Xerox Wide Format 6605 User Manual

2. If you enter an incorrect value, press the C button to clear the entry and then enter
the correct value.
Step 3: Copying the Original
The Scanner has a fixed timer between seeing the document and starting the document
load action. Therefore, it is essential that you follow the details below paying close
attention to the orientation and timing as you load the original. Improperly loading the
original may cause misfeed and skewed images.
1. Align the original (image face up) with the Left Justified ruling on the Feed-in Shelf.
Do not load the original beyond the “no paper zone” as this is where the Drive Gears
are located and may cause a jam. Hold the origina both hands and quickly slide it
into the Scanner until it stops. Do not let go. The motor will start as the document is
detected. Once the Scanner detects the original, it prefeeds in and out, in again and
completes the scan and exits just below the scanner.
If the document does not feed automatically, the Scan Start mode may be set to
Use Start Key. In this case, press the Start button on the Control Panel. For more
information refer to System Administration, Set Start Scan mode.
2. If there are Document Catch Guides in the front of the machine, you may wish to
guide the lead edge of the documents as they travel downward into the guides.
Refer to Making Copies using the Manual Feed-in Shelf (Bypass)next in this chapter
for more details and options available.
Xerox
®
Wide Format 6604/6605 Solution
™
2-6
User Guide
Printing and Copying Documents

Xerox Wide Format 6605 Specifications

General

Brand	Xerox
Model	Wide Format 6605
Category	Printer
Language	English