6.3 Installing the Control Bus Interface Card to
a PC
The VF702 is installed in a slot of a PC (PC/A
T compatible). The card is used for connecting
the computer to the V net. This section explains how to install the VF702 in a PC.
SEE
ALSO
For more information about how to treat PCs when installing VF702, refer to:
The instruction manuals of the target PCs
n
Installation Procedure
1.
Turn off the power of the PC. For safety, remove the power plug from the outlet.
2. Set the station address for the VF702.
3. Remove the cover of the PC.
4. Insert the VF702 in the corresponding slot and fix it to the slot.
5. Put back the cover of the PC.
6. Write the station address on the label that comes with the VF702 and stick it on the front
or another easy-to-see location of the PC.
SEE
ALSO
For more information about station address setting, refer to:
6.2, “Setting Control Bus Interface Card Station Address” on page 6-3
For more information about the label used to record the station address, refer to:
6.5, “Attaching the V net Station Address Label” on page 6-10
For more information about installing VF702 driver to the PC, refer to:
B3.3, “Configuring Network Settings” in Installation (IM 32Q01C50-31E)
<6.3 Installing the Control Bus Interface Card to a PC > 6-7
IM 32Q06C10-31E 4th Edition : Jan.30,2015-00
To Next Page
Loading...
Need help?
General
