1.5.1 Pressure Clamp Terminal Blocks
The pressure clamp terminal block is used for wiring the field devices directly to the I/O mod-
ule.
The pressure clamp terminal block for single use and dual-redundant use are dif
ferent.
n
Types of Pressure Clamp Terminal Blocks
The following types of pressure clamp terminal blocks are available.
Table 1.5.1-1 Pressure Clamp Terminal Blocks
Configuration Model Name I/O points
Single
STA4S Pressure clamp terminal block for analog I/O 16-channel
STB4S Pressure clamp terminal block for digital I/O 16-channel
Dual-redundant
STA4D
Dual-redundant pressure clamp terminal block for
analog I/O
16-channel
STB4D
Dual-redundant pressure clamp terminal block for
digital I/O
16-channel
n
External V
iew of Pressure Clamp Terminal Blocks
The models of pressure clamp terminal blocks are shown in the table above. Though the in-
ternal circuits vary with the number of channels, analog or digital signals or input/output, the
external dimensions and appearance are the same. The following figure shows the terminal
blocks for single and dual-redundant configurations.
For dual-redundant configurationFor single configuration
Figure 1.5.1-1 External View of Pressure Clamp Terminal Blocks
<1.5 Accessories Related to Input/Output Modules > 1-20
IM 32Q06C10-31E 4th Edition : Jan.30,2015-00
To Next Page
Loading...
Need help?
General
