ABB ACS380 User Manual

Connector pitch 5 mm, maximum wire size 2.5 mm
2
(14 AWG)EIA-485 embedded
fieldbus (A+, B-,
BGND)
Physical layer: RS-485
Cable type: Shielded twisted pair cable with twisted pair for data and a
wire or pair for signal ground, nominal impedance 100 … 165 ohm, for
example Belden 9842
Transmission rate: 9.6 … 115.2 kbit/s
Termination by jumper
EIA-485, male RJ-45 connector, cable type CAT 5e or better, maximum
cable length 100 m (328 ft)
Control panel - drive
connection
USB Type A – Type Mini-B cable, maximum cable length 3 m (9.8 ft)Control panel - PC
connection
Brake resistor connection data
The brake resistor output is conditionally short-circuit proof by
IEC/EN 61800-5-1 and UL 61800-5-1.
Short-circuit protec-
tion (IEC 61800-5-1,
IEC 60439-1,
UL 61800-5-1)
Rated conditional short-circuit current is as defined in IEC 60439-1.
Energy efficiency data (EU ecodesign)
Energy efficiency data according to IEC 61800-9-2 is available from the ecodesign tool
at https://ecodesign.drivesmotors.abb.com/.
Energy efficiency data is not provided for 1-phase 230 V drives. The drives with 1-phase
input are not in the scope of the EU ecodesign requirements (Regulation EU 2019/1781).
Protection classes
IP20. The drive must be installed in a cabinet to fulfill the requirements
for shielding from contact.
Degree of protection
(IEC/EN 60529)
UL open type. For indoor use only. UL Type 1 kit is available as an option.Enclosure types
(UL 61800-5-1)
lllOvervoltage category
(IEC 60664-1)
lProtective classes
(IEC/EN 61800-5-1)
Ambient conditions
Environmental limits for the drive are given below. The drive must be used in a heated
indoor controlled environment.
Technical data 155

ABB ACS380 Specifications

General

Brand	ABB
Model	ACS380
Category	DC Drives
Language	English