130 Technical data
Applicable standards
Grid codes
See ACS800-67LC wind turbine converters system description and start-up guide
[3AUA0000059432 (English)].
CE marking
A CE mark is attached to the converter to verify that the unit follows the provisions of the
European Low Voltage and EMC Directives.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to
standard EN 61800-5-1 and applicable parts of standard EN 60204-1.
Compliance with the European EMC Directive
See section Compliance with the EN 61800-3.
Compliance with the European Machinery Directive
The converter complies with the European Machinery Directive requirements for a partly
completed machinery.
The converter complies with the standards below. The compliance with the
European Low Voltage Directive is verified according to standards EN 61800-5-1
and EN 60204-1.
• IEC/EN 60204-1:2006 Safety of machinery. Electrical equipment of machines. Part 1: General
requirements. Provisions for compliance: The final assembler of the machine is
responsible for installing
- an emergency-stop device.
• IEC/EN 60529:2001 Degrees of protection provided by enclosures (IP code).
• IEC/EN 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
• IEC/EN 61400-1:2005 Wind turbines. Part 1: design requirements.
• IEC/EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3: EMC requirements and
specific test methods.
• IEC/EN 61800-5-
1:2007
Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy.
• UL 50 Twelfth Edition. Enclosures for Electrical Equipment, Non-Environmental
Considerations.
• UL 508A First Edition. Industrial Control Panels.
To Next Page
Loading...
Need help?
General
