Name: APRILIA SX 125
Brand: APRILIA
Rating: 4 (1 reviews)

To Next Page

To Previous Page

•

Place the extractor plate.

•

Fit the three fixing screws.

•

Adequately centre the plate with refer-

ence to the crankshaft.

•

Tighten the three fixing screws.

•

Screw the long threaded end of the ex-

tractor screw on the extractor plate un-

til the crankcase half on the clutch side

starts to get detached. Facilitate the

detachment of the crankcase by tap-

ping the secondary shaft with a rubber

mallet, being careful that the crank-

case half gets detached evenly. Be ex-

tremely careful not to tap the seal

surfaces.

•

Check the thrust washer of the main

shaft. When detaching the crankcase,

the washer may get glued inside the

crankcase halves.

•

Once the crankcase halves have been

detached, remove the extracting tool

before the crankcase halves are fully

apart.

Specific tooling

AP0277455 Extractor plate to separate the

crankcase halves

Removing the crankshaft

•

Turn the crankcase halves on the sup-

port so that the high ignition is facing

upwards.

Engine RX SX 125

ENG - 116

Questions and Answers:

Need help?

Do you have a question about the APRILIA SX 125 and is the answer not in the manual?

APRILIA SX 125 Specifications

General