Name: APRILIA SX 125
Brand: APRILIA
Rating: 4 (1 reviews)

To Next Page

To Previous Page

13.12.2x22x2 Plain iron washer

14.M12 lower self-locking nut

15.TE flanged screw M6x20

16.Bushing

17.Clip M6

Adjusting

The rear shock absorber standard setting is adjusted to suit most low speed riding conditions, whether

the vehicle is partially or fully loaded.

However, this setting can be personalised to meet specific needs according to vehicle use.

CAUTION

ALLOW ENGINE AND SILENCER TO COOL OFF BEFORE OPERATING THE SET SCREWS.

THE SET NUT MUST NOT BE TIGHTEN OVER 25 mm (0.98 in) FROM THE BEGINNING OF THE

THREAD. IF SUCH DISTANCE IS EXCEEDED, THERE WILL BE SOME JERKING WHILE RIDING

EVEN ON SOME SLIGHTLY UNEVEN ROADS.

•

Operate on the set nut (1) (shock ab-

sorber spring preloading adjustment).

CAUTION

TURN THE SET NUT (1) GRADUALLY ONE TURN AT A

TIME.

TRY RIDING THE VEHICLE ON THE STREET UNTIL THE

OPTIMUM ADJUSTMENT IS OBTAINED.

REAR SHOCK ABSORBER ADJUSTMENT

Specification

Desc./Quantity

By tightening the set nut (1) Spring (2) preloading increases

The scooter suspension is very hard.

Advisable for smooth or ordinary roads and when riding with

passenger.

By loosening the set nut (1) Spring (2) preloading decreases

The vehicle suspension is very soft.

Advisable for uneven roads, without passengers.

RX SX 125 Suspensions

SUSP - 167

Questions and Answers:

Need help?

Do you have a question about the APRILIA SX 125 and is the answer not in the manual?

APRILIA SX 125 Specifications

General