APRILIA SX 125 User Manual

•
Slide off the stem downwards, being careful not to damage its surface.
Draining oil
CAUTION
THE FOLLOWING OPERATIONS REFER TO A SINGLE WHEEL HOLDER STEM / SLEEVE BUT
APPLY TO BOTH.
•
Remove the wheel holder stem / sleeve unit.
•
Clean the wheel holder stem / sleeve unit thoroughly.
CAUTION
BEFORE CARRYING OUT THE OPERATIONS BELOW, GET A +440 cm³ (26.85 cu.in) CONTAINER
TO COLLECT THE OIL.
•
Place the sleeve in a vice fitted with
protection shoes.
CAUTION
THE WHEEL HOLDER STEM SLEEVE UNIT CONTAINS
OIL. DO NOT TURN IT OVER OR TILT IT TOO MUCH WHEN
REMOVING IT.
•
Unscrew and remove the upper cap of
the shock absorber rod.
•
With an open wrench keep the lock nut
firm on the shock absorber rod and un-
lock the upper cap.
Suspensions RX SX 125
SUSP - 148

APRILIA SX 125 Specifications

General

Displacement	124.2 cc
Cooling System	Liquid cooled
Fuel System	Electronic fuel injection
Transmission	6-speed
Rear Suspension	Monoshock
Front Tire	100/80-17
Rear Tire	130/70-17
Compression Ratio	12.5:1
Starter	Electric
Clutch	Wet multi-plate
Front Brake Disc	300 mm
Rear Brake Disc	220 mm
Dry Weight	134 kg
Bore x Stroke	58 mm x 47 mm
Max Power	11 kW (15 HP) @ 10, 000 rpm
Front Suspension	41 mm USD fork
Front Brake	Single 300 mm disc
Rear Brake	Single disc
Fuel Tank Capacity	7 liters
Frame	Steel perimeter
Engine Type	Single-cylinder, 4-stroke