System overview ACTA 4000 User Guide
10 (136) 2008-12 9836 4171 01
Tool calibration If the tool needs adjustment, this is normally done through the ACTA
calibration procedure where the tool software is updated. A calibration can also
be done manually (screw adjustment on tool).
The tool calibration can be done with or without a synchronized controller. For
instructions, see section Calibrating tools and equipment.
Tool data handling
Tool data and the results of the measurements from the tightening operations
are stored in ACTA.
The data can be stored and handled in a number of ways. Printouts through a
PC or data handling in ToolsTalk QAT can be made.
ACTA calibration ACTA needs to be calibrated once a year. This is done in a licensed laboratory.
Transducer calibration To calibrate a transducer, deadweight equipment is used.
1.3.1 Revision History
The release of this user guide describes:
To Next Page
Loading...
Need help?
General
