ACTA 4000 User Guide Getting started
9836 4171 01 2008-12 17 (136)
3 Getting started
This section describes how to get started and configure ACTA.
3.1 Out of the Box
When purchasing ACTA 4000, any version, the following is included:
Mains AC power supply cable
User guide and Product Information
Calibration certificate
USB cable
CD with ACTA software, ToolsTalk QAT software, and ACTA 4000 Printer Service
The calibration certificate must be stored in a safe place.
To access the functionality described in this user guide when using an ACTA 3000, an upgrade package is
required. Contact your Atlas Copco representative for details.
3.2 Installation
ACTA is a standalone portable product. No particular installation is necessary. Simply follow the safety
instructions and observe the following recommendations:
1. Place ACTA on a firm and flat surface or hold it securely in your hand.
2. Connect your Atlas Copco torque transducer.
3. Connect the power supply cable.
4. Start ACTA by pressing
On button until the buzzer beeps.
The first time you charge the battery, charge it for 12 hours and then use ACTA on
battery mode until the battery is completely discharged.
To Next Page
Loading...
Need help?
General
