ACTA 4000 User Guide Programming ACTA
9836 4171 01 2008-12 53 (136)
4.5.6 Product information
The following product information is shown.
ACTA 3000 ACTA 4000
ACTA serial number ACTA serial number
ACTA mode ACTA mode
HW revision HW revision
SW revision SW revision
Calibration date mV/V Calibration date mV/V
Next cal. Date mV/V Next Calibration date mV/V
Calibration date V
Next cal date V
Calibration date gyro
Next cal date gyro
When ACTA is powered up, a check of the next calibration date is performed:
If there are less than 30 days to the next calibration date, a message dialog box
appears telling the operator that ACTA needs to be calibrated before the next
calibration date.
If the next calibration date has passed, a message dialog box appears telling the
operator that your ACTA needs to be calibrated. Contact your Atlas Copco service
representative to recalibrate and reset the transducer.
4.5.7 Options
The options are customer specialized features that can be enabled in ACTA 4000.
They are not described in this manual. For further information, please contact your Atlas Copco
representative.
To Next Page
Loading...
Need help?
General
