Note: If the coder lists of both IP and Tel Profiles apply to the same call, only the
coders common to both are used. The order of the coders is determined by the
preference.
5. Configure the parameters as required. For a description of each parameter, refer to
the corresponding "global" parameter.
6. Click Submit to apply your changes.
18.4 Configuring IP Profiles
The IP Profile Settings table allows you to define up to nine configuration profiles for IP
calls. These profiles are termed IP Profiles. The IP Profile Settings table contains a list of
parameters, which can also be configured globally for all calls using their corresponding
"global" parameters. The only difference between the IP Profile parameters and the global
parameters regarding description may be their default values.
IP Profiles provide high-level adaptation when the device interworks between different
equipment and protocols (at both the Tel and IP sides), each of which may require different
handling by the device. Once configured, IP Profiles can be assigned to specific inbound
and/or outbound calls. Therefore, IP Profiles enable you to assign special configuration
settings for device handling of specific calls. For example, if specific IP calls require the use
of the G.711 coder, you can configure an IP Profile with this coder and assign it to these
calls.
IP Profiles can be assigned to IP calls in the following tables:
To Next Page
Loading...
Need help?
General
