AudioCodes MediaPack Series MP-11x User Manual

Version 6.6 327 MP-11x & MP-124
User's Manual 31. Software Upgrade
31 Software Upgrade
The Software Update menu allows you to upgrade the device's software, install Software
Upgrade Key, and load/save configuration file. This menu includes the following page
items:

Load Auxiliary Files (see 'Loading Auxiliary Files' on page 327)

Software Upgrade Key (see 'Loading Software Upgrade Key' on page 338)

Software Upgrade Wizard (see 'Software Upgrade Wizard' on page 341)

Configuration File (see 'Backing Up and Loading Configuration File' on page 344)
31.1 Loading Auxiliary Files
Various Auxiliary files can be installed on the device. These Auxiliary files provide the
device with additional configuration settings. The table below lists the different types of
Auxiliary files:
Table 31-1: Auxiliary Files
File Description
INI Configures the device. The Web interface enables practically full device
provisioning. However, some features may only be configured by ini file or you
may wish to configure your device using the ini file. For more information on
using the ini file to configure the device, see 'INI File-Based Management' on
page 87.
Call Progress
Tones
Region-specific, telephone exchange-dependent file that contains the Call
Progress Tones (CPT) levels and frequencies for the device. The default CPT
file is U.S.A. For more information, see 'Call Progress Tones File' on page 329.
Prerecorded
Tones
The Prerecorded Tones (PRT) file enhances the device's capabilities of playing
a wide range of telephone exchange tones that cannot be defined in the CPT
file. For more information, see Prerecorded Tones File on page 333.
Dial Plan Provides dialing plans, for example, to know when to stop collecting dialed digits
and start forwarding them or for obtaining the destination IP address for
outbound IP routing. For more information, see 'Dial Plan File' on page 334.
User Info The User Information file maps PBX extensions to IP numbers. This file can be
used to represent PBX extensions as IP phones in the global 'IP world'. For
more information, see 'User Information File' on page 336.
The Auxiliary files can be loaded to the device using one of the following methods:

Web interface.

TFTP: This is done by specifying the name of the Auxiliary file in an ini file (see
Auxiliary and Configuration Files Parameters) and then loading the ini file to the
device. The Auxiliary files listed in the ini file are then automatically loaded through
TFTP during device startup. If the ini file does not contain a specific auxiliary file type,
the device uses the last auxiliary file of that type that was stored on its non-volatile
memory.

AudioCodes MediaPack Series MP-11x Specifications

General

Brand	AudioCodes
Model	MediaPack Series MP-11x
Category	Gateway
Language	English