Parameter Description
Web: Cost Group > Time
Band Table
EMS: Time Band
Provisioning > Time Band
[CostGroupTimebands]
This table parameter configures time bands and associates them with
Cost Groups.
[CostGroupTimebands]
FORMAT CostGroupTimebands_TimebandIndex =
CostGroupTimebands_StartTime, CostGroupTimebands_EndTime,
CostGroupTimebands_ConnectionCost,
CostGroupTimebands_MinuteCost;
[\CostGroupTimebands]
Note: For a detailed description of this table, see 'Configuring Time
Bands for Cost Groups' on page 168.
43.12 Standalone Survivability Parameters
The Stand-alone Survivability (SAS) parameters are described in the table below.
Table 43-61: SAS Parameters
Parameter Description
Web: Enable SAS
EMS: Enable
[EnableSAS]
Enables the Stand-Alone Survivability (SAS) feature.
 [0] Disable (default)
 [1] Enable
When enabled, the device receives the registration requests
from different SIP entities in the local network and then forwards
them to the defined proxy. If the connection to the proxy fails
('Emergency Mode'), the device serves as a proxy by allowing
calls internal to the local network or outgoing to PSTN.
Note: For this parameter to take effect, a device reset is
required.
Web: SAS Local SIP UDP Port
EMS: Local SIP UDP
[SASLocalSIPUDPPort]
Defines the local UDP port for sending and receiving SIP
messages for SAS. The SIP entities in the local network need to
send the registration requests to this port. When forwarding the
requests to the proxy ('Normal Mode'), this port serves as the
source port.
The valid range is 1 to 65,534. The default value is 5080.
Web: SAS Default Gateway IP
EMS: Default Gateway IP
[SASDefaultGatewayIP]
Defines the Default Gateway used in SAS 'Emergency Mode'.
When an incoming SIP INVITE is received and the destination
Address-Of-Record is not included in the SAS database, the
request is immediately sent to this default gateway.
The address can be configured as an IP address (dotted-
decimal notation) or as a domain name (up to 49 characters).
You can also configure the IP address with a destination port,
e.g., "10.1.2.3:5060". The default is a null string, i.e., the local IP
address of the gateway.
Web: SAS Registration Time
EMS: Registration Time
[SASRegistrationTime]
Defines the value of the SIP Expires header that is sent in a 200
OK response to an incoming REGISTER message when in SAS
'Emergency Mode'.
The valid range is 0 (Analog) to 2,000,000. The default value is
20.
To Next Page
Loading...
Need help?
General
