AudioCodes MediaPack Series MP-11x User Manual

Version 6.6 267 MP-11x & MP-124
User's Manual 25. Analog Gateway
 To configure automatic dialing per port:
1. Open the Automatic Dialing page (Configuration tab > VoIP menu > GW and IP to IP
submenu > Analog Gateway > Automatic Dialing).
Figure 25-5: Automatic Dialing Page
The first table entry in the figure above enables Hotline automatic dialing for an FXS
port, whereby if the port is off-hooked for over 15 seconds, the device automatically
dials 911.
2. Configure automatic dialing per port, as required. See the table below for parameter
descriptions.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 324.
Table 25-3: Automatic Dialing Table Parameter Description
Parameter Description
Gateway Port
Lists the FXS or FXO port for which you want to configure automatic
dialing.
Destination Phone Number
[TargetOfChannel_Destina
tion]
Defines the destination telephone number to automatically dial.
Auto Dial Status
[TargetOfChannel_Type]
Enables automatic dialing.
 [0] Disable = Automatic dialing for the specific port is disabled.
 [1] Enable = (Default) Automatic dialing is enabled and the phone
number configured in the 'Destination Phone Number' field is
automatically dialed if the following occurs:

FXS interfaces: The phone is off-hooked

FXO interfaces: A ring signal (from a PBX/PSTN switch) is
detected on the FXO line. The device initiates a call to the
destination without seizing the FXO line. The line is seized only
after the SIP call is answered.
 [2] Hotline = Automatic dialing is done after an interval configured
by the 'Hotline Dial Tone Duration' parameter:

FXS interfaces: When the phone is off-hooked and no digit is
dialed within a user-defined time, the configured destination

AudioCodes MediaPack Series MP-11x Specifications

General

Brand	AudioCodes
Model	MediaPack Series MP-11x
Category	Gateway
Language	English