 [1] = Enable
When enabled, the device retrieves the Web user’s login
username from the smart card, which is automatically displayed
(read-only) in the Web Login screen; the user is then required to
provide only the login password.
Typically, a TLS connection is established between the smart
card and the device’s Web interface, and a RADIUS server is
implemented to authenticate the password with the username.
Thus, this feature implements a two-factor authentication - what
the user has (the physical card) and what the user knows (i.e.,
the login password).
EMS: HTTPS Port
[HTTPport]
Defines the LAN HTTP port for Web management (default is
80). To enable Web management from the LAN, configure the
desired port.
Note: For this parameter to take effect, a device reset is
required.
EMS: Disable WEB Config
[DisableWebConfig]
Determines whether the entire Web interface is read-only.
 [0] = (Default) Enables modifications of parameters.
 [1] = Web interface is read-only.
When in read-only mode, parameters can't be modified. In
addition, the following pages can't be accessed: 'Web User
Accounts', 'Certificates', 'Regional Settings', 'Maintenance
Actions' and all file-loading pages ('Load Auxiliary Files',
'Software Upgrade Wizard', and 'Configuration File').
Notes:
 For this parameter to take effect, a device reset is required.
 To return to read/write after you have applied read-only
using this parameter (set to 1), you need to reboot your
device with an ini file that doesn't include this parameter,
using the AcBootP utility.
[ResetWebPassword]
Determines whether the device resets the username and
password of the primary ("Admin") and secondary ("User")
accounts to their default settings and deletes all other users that
may have been configured.
 [0] = (Default) Password and username retain their values.
 [1] = Password and username are reset.
Notes:
 For this parameter to take effect, a device reset is required.
 The username and password cannot be reset from the Web
interface (i.e., via AdminPage or by loading an ini file).
[ScenarioFileName]
Defines the file name of the Scenario file to be loaded to the
device. The file name must have the .dat extension and can be
up to 47 characters. For loading a Scenario using the Web
interface, see Loading a Scenario to the Device on page 53.
To Next Page
Loading...
Need help?
General
