Brother MFC-8535DN Service Manual

5-15
Confidential
1.3.9 Change OnePushDemo function setting (function code: 28)
<Function>
This function is used to implement Demo printing by pressing a certain key, and is mainly
used for sales promotion at dealers. This function is disabled once printing is performed from
the computer. Change the setting to enable the function again.
OnePushDemo = ON(Enabled) / OFF(Disabled).
The setting currently selected is marked "*".
<Operating Procedure>
(1) Press the [2], and then the [8] key in the initial state of maintenance mode.
"OnePushDemo=ON *" is displayed on the LCD.
(2) Press the [▲] or [▼] key to display "OnePushDemo=ON" when enabling this function or
"OnePushDemo=OFF" when disabling this function.
(3) Press the [SET] or [Mono Start] key. The setting currently displayed is saved, and the
machine returns to the initial state of maintenance mode.
Note:
• To cancel operation and return to the initial state of maintenance mode, press the [X] key.
• Once the OnePushDemo function is enabled, this will not be disabled even when
printing is performed from the computer as long as the power switch is not turned OFF.
However, if the power switch is turned OFF and then ON again after the OnePushDemo
function was enabled, this function will be disabled when printing is performed from the
computer.

Brother MFC-8535DN Specifications

General

Brand	Brother
Model	MFC-8535DN
Category	All in One Printer
Language	English