5-35
Confidential
1.3.20 Continuous print test (function code: 67)
<Function>
This function is used to conduct paper feed and eject tests while printing patterns.
<Operating Procedure>
(1) Press the [6], and then the [7] key in the initial state of maintenance mode. "SELECT: K
100%" is displayed on the LCD.
(2) Refer to the <Print pattern> table, press the
[â–²] or [â–¼]
key to select the print pattern, and
press the [SET] key. For total pattern printing, proceed to the procedure (8). Otherwise,
"SELECT: A4" is displayed on the LCD.
(3)
Refer to the <Paper size> table, press the [â–²] or [â–¼] key to select the paper size, and press
the [SET] key. "SELECT: PLAIN" is displayed on the LCD.
(4) Refer to the <Print specification> table, press the [â–²] or [â–¼] key to select the media
specification, and press the [SET] key. "SELECT: TRAY1 SX" is displayed on the LCD.
(5) Refer to the <Print type> table, press the [â–²] or [â–¼] key to select the print type, and
press the [SET] key. "SELECT: 1PAGE" is displayed on the LCD.
(6) Refer to the <Print page> table, press the [â–²] or [â–¼] key to select the pages printing,
and press the [SET] key. For intermittent pattern printing, "SELECT: 1P/JOB" is
displayed on the LCD. For other printings, or move on to the procedure (8).
(7) Refer to the <Number of pages per job> table, press the [â–²] or [â–¼] key to select the
number of pages for 1 job, and press the [SET] key.
(Only for intermittent pattern printing)
(8) "PAPER FEED TEST" is displayed on the LCD, and printing test pattern starts using the
selected conditions.
(9) When printing is completed, the machine returns to the initial state of maintenance
mode.
To Next Page
Loading...
Need help?
General
