App. 2-1
Confidential
APPENDIX 2 DELETING USER SETTING
INFORMATION
The user setting information for the machine is stored in the main PCB. You can return this to
the default settings by following the procedure below.
<Operating Procedure>
(1) Press the [Settings] key while the machine is in the ready state.
(2) Press the [All Settings] key on the LCD.
(3) Press the [Initial Setup] key on the LCD.
(4) Press the [Reset] key on the LCD.
(5) Press the [Factory Reset] key on the LCD.
(6) "Factory Reset? It may take time until reset finishes. Yes No" appears on the LCD. Press
the [Yes] key.
(7) "Machine will reboot after resetting. Press [OK] for 2 seconds to confirm." appears on the
LCD. Press and hold the [OK] key for 2 seconds or longer to delete the user setting
information and return the machine to the ready state.
To Next Page
Loading...
Need help?
General
