2-37
Confidential
A0 15 Time-out: 13 seconds or more for one-line transmission. 2-123
A0 16 RTC not found or carrier OFF detected for 6 seconds. 2-123
A0 17
RTC found but no command detected for 60 seconds or
longer.
2-123
A0 19 No video data to be sent. 2-123
A0 20 Cannot continue receiving color fax (remaining ink low). 2-123
A8 01 RTN, PIN, or ERR received (sending terminal). 2-123
A9 01 RTN, PIN, or ERR sent (receiving terminal). 2-123
AA 18 Receive buffer full during receiving data into memory. 2-123
B0 01 Polarity reversion detected. 2-123
B0 02 Unable to receive the next-page data. 2-123
B0 03
Unable to receive polling during turn-around transmission
due to call reservation.
2-123
B0 04 PC interface error 2-123
C0 01 No common modulation mode or failed to poll. 2-123
C0 02 Unable to detect JM. 2-123
C0 03 Unable to detect CM. 2-123
C0 04 Unable to detect CJ. 2-123
C0 10 Cannot finish V. 34 negotiation or training. 2-123
C0 11 Modem error detected during V. 34 negotiation or training. 2-123
C0 20 Modem error detected while sending commands. 2-123
C0 21 Modem error detected while receiving commands. 2-123
C0 22 Control channel connection time-out. 2-123
C0 30 Modem error detected while sending video signals. 2-123
C0 31 Modem error detected while receiving video signals. 2-123
E0 01 Failed to detect 1,300 Hz signal in burn-in operation. 2-123
E0 02 Failed to detect PB signals in burn-in operation. 2-123
E0 03
Unable to detect commands in burn-in operation when
RS232C is used.
2-123
Code 1 Code 2 Cause Refer to:
To Next Page
Loading...
Need help?
General
