Installing an Actuator Button SFP Module
To install this type of SFP or SFP+ module, follow these steps:
1. Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
2. Line up the SFP module with the port and slide it in until the actuator button clicks into place as shown
in the following figure. Be sure not to press the actuator button as you insert the SFP module because you
might inadvertently disengage the SFP module from the port.
Figure 55: Installing an Actuator Button SFP or SFP+ Module
When installing an SFP module, you should hear a click as the triangular pin on the bottom of the SFP module
snaps into the hole in the receptacle, indicating that the module is correctly seated and secured in the receptacle.
Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line card
by firmly pushing on each SFP module.
Note
Removing an Actuator Button SFP or SFP+ Module
To remove this type of SFP or SFP+ module, follow these steps:
1. Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
2. Disconnect and remove all interface cables from the ports; note the current connections of the cables to
the ports on the line card.
3. Gently press the actuator button on the front of the SFP module until it clicks and the latch mechanism
activates, releasing the SFP module from the port (see the figure below).
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
102
Installing and Removing Line Cards and Transceiver Modules
Installing an Actuator Button SFP Module
To Next Page
Loading...
Need help?
General
