Cisco A9K-MOD400-TR User Manual

Figure 81: Cable-Management Bracket Installation and Removal
Removing a Line Card Cable-Management Bracket
To remove a line card cable-management bracket, follow these steps (see Installing a Line Card Cable
Management Bracket, on page 127):
1. Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
2. Note the current interface cable connections to the ports on each line card.
3. Starting with the interface cable for the bottom port on the line card, disconnect the cable from the line
card interface.
4. Repeat Step 3 for all remaining interface cables, proceeding from the bottom ports upward, then proceed
to Step 5.
5. Loosen the captive installation screw on the cable-management bracket and remove the bracket from the
line card (Figure 81: Cable-Management Bracket Installation and Removal, on page 128).
For information on connecting and disconnecting interface cables, see Installing and Removing Fibre-Optic
Interface Cables..
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
128
Installing and Removing Line Cards and Transceiver Modules
Removing a Line Card Cable-Management Bracket

Cisco A9K-MOD400-TR Specifications

General

Brand	Cisco
Model	A9K-MOD400-TR
Category	Network Router
Language	English