2. Inspect and clean the LC connector’s fiber-optic end faces.
3. Remove the dust plugs from the XFP transceiver module optical bores.
4. Immediately attach the network interface cable LC connectors to the XFP transceiver module (see the
figure below) for an illustration of cabling the XFP transceiver module).
Figure 64: Cabling a 10-Gigabit Ethernet XFP Transceiver Module
Installing and Removing 100-Gigabit Ethernet CFP Transceiver
Modules
This section provides the installation, cabling, and removal instructions for the Cisco 100-Gigabit C Form-factor
Pluggable (CFP) transceiver modules. The modules are hot-swappable input/output (I/O) devices that connect
the system’s module port electrical circuitry with either a copper or a fiber-optic network.
Overview
The Cisco 100-Gigabit Ethernet CFP transceiver modules are hot-swappable I/O devices that plug into
100-Gigabit Ethernet module ports.
Note: The dual SC connectors on the optical CFP transceivers support network interface cables with either
Physical Contact (PC) or Ultra-Physical Contact (UPC) flat polished face types. The dual SC connectors on
the optical CFP transceivers do not support network interface cables with an Angle Polished Connector (APC)
polished face type.
Note
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
111
Installing and Removing Line Cards and Transceiver Modules
Installing and Removing 100-Gigabit Ethernet CFP Transceiver Modules
To Next Page
Loading...
Need help?
General
