Line card status LED7Port 0 SFP+ cage3
Port 11 SFP+ cage4
24-Port 10-Gigabit Ethernet/Gigabit Ethernet Line Card with SFP+ or SFP
Oversubscription will be supported on this line card in a future release of IOS XR 6.2.x train.
Note
The 24-Port 10-Gigabit Ethernet (10GE)/Gigabit Ethernet (GE) line card has twenty-four dual-rate ports that
accept 10GE SFP+ or 1GE SFP modules.
The 24-port line card has a single Network Processor Unit (NPU). Configuring more than 20x10GE ports per
NPU could result in line drops across all ports, depending on the packet size and traffic type. See Configuring
the Dual-Rate Line Cards for information on specifying the port speed.
Note
The 24-Port 10GE/1GE line card is available in these variants:
• -SE (Service Edge Optimized)
• -TR (Packet Transport Optimized)
• -CM (Consumption Model)
The -SE and -TR variants are functionally equivalent, but vary in configuration scale and buffer capacity. The
-CM variant is same as the -SE variant except that the -CM variant functions on Consumption Based Pricing
Model supported with Smart Licensing. For details related to the Consumption Based Pricing Model, see the
chapter Software Entitlement in the Cisco ASR 9000 Series Aggregation Services Router System Management
Configuration Guide.
Each SFP+ cage on the 24-Port 10GE/1GE line card has an adjacent Link LED visible on the front panel. The
Link LED indicates the status of the associated SFP+ port, as described in Line Card LEDs, on page 138.
The following figure shows the 24-Port 10GE/1GE line card front panel connectors and indicators.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
29
Overview
24-Port 10-Gigabit Ethernet/Gigabit Ethernet Line Card with SFP+ or SFP
To Next Page
Loading...
Need help?
General
