PurposeCommand or Action
Displays the running configuration.
show run interface value
Example:
RP/0/RSP0/CPU0:router# show run interface
Step 13
tengige0/1/0/5
Fri Aug 3 19:57:14.184 UTC
interface TenGigE0/1/0/5
ptp
profile tp64
transport ipv4
port state slave-only
master ipv4 1.7.1.2
!
announce timeout 2
!
ipv4 address 1.7.1.1 255.255.255.0
transceiver permit pid all
!
Configuring the Clock Interface for a PTP Master
Use these steps to configure a clock interface for the PTP master:
SUMMARY STEPS
1.
configure
2.
clock-interface sync value location node
3.
port-parameters dti
4.
frequency synchronization
5.
selection input
6.
priority number
7.
wait-to-restore number
8.
ssm disable
9.
quality receive exact itu-t option number generation number PRS
10.
Use one of these commands:
•
end
•
commit
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
243
Configuring PTP
Configuring the Clock Interface for a PTP Master
To Next Page
Loading...
Need help?
General
