Setting an IP Precedence Value for SNMP Traffic: Example
The following example shows how to set the SNMP IP Precedence value to 7:
configure
snmp-server ipv4 precedence 7
exit
Uncommitted changes found, commit them before exiting(yes/no/cancel)? [cancel]: y
Setting an IP DSCP Value for SNMP Traffic: Example
The following example shows how to set the IP DSCP value of SNMP traffic to 45:
configure
snmp-server ipv4 dscp 45
exit
Uncommitted changes found, commit them before exiting(yes/no/cancel)? [cancel]: y
Additional References
The following sections provide references related to Implementing SNMP on Cisco IOS XR software.
Related Documents
Document TitleRelated Topic
SNMP Server Commands on the Cisco ASR 9000
Series Router module of Cisco ASR 9000 Series
Aggregation Services Router System Management
Command Reference
Cisco IOS XR SNMP commands
Cisco ASR 9000 Series Aggregation Services Routers
MIB Specifications Guide
MIB information
Cisco ASR 9000 Series Aggregation Services Router
Commands Master List
Cisco IOS XR commands
Cisco ASR 9000 Series Aggregation Services Router
Getting Started Guide
Getting started with Cisco IOS XR software
Configuring AAA Services on the Cisco ASR 9000
Series Router module of Cisco ASR 9000 Series
Aggregation Services Router System Security
Configuration Guide
Information about user groups and task IDs
Cisco ASR 9000 Series Aggregation Services Router
Modular Quality of Service Configuration Guide
Cisco IOS XR Quality of Service
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
380
Implementing SNMP
Setting an IP Precedence Value for SNMP Traffic: Example
To Next Page
Loading...
Need help?
General
