Info: 4, 9, 10, 14, 15, 17, 18
Proceed with removing these packages? [confirm] y
The install operation will continue asynchronously.
Install operation 30 completed successfully at 23.
Pausing Before Configuration Lock: Example
The following example shows how to deactivate a package, pausing the operation before locking the
configuration for the actual software deactivation. While the operation is paused, you can enter a configuration
mode and perform configurations. When you want to complete the operation, enter the install operation id
complete command, or the install operation id attach synchronous command.
RP/0/RSP0/CPU0:router(admin)# install deactivate disk0:comp-asr9k
-3.7.2.07I.CSCsr09575-1.0.0 pause sw-change
Install operation 12 '(admin) install deactivate
disk0:comp-asr9k-3.7.2.07I.CSCsr09575-1.0.0 pause sw-change'
started by user 'admin' via CLI at 09:06:26 BST Mon Jul 07 2009.
Info: This operation will reload the following nodes in parallel:
Info: 0/0/CPU0 (RP) (SDR: Owner)
Info: 0/1/CPU0 (LC(E3-GE-4)) (SDR: Owner)
Info: 0/5/CPU0 (LC(E3-OC3-POS-4)) (SDR: Owner)
Proceed with this install operation (y/n)? [y]
The install operation will continue asynchronously.
Info: Install Method: Parallel Reload
Info: Install operation 12 is pausing before the config lock is applied for
Info: the software change as requested by the user.
Info: No further install operations will be allowed until the operation is resumed.
Info: Please continue the operation using one of the following steps:
Info: - run the command '(admin) install operation 12 complete'.
Info: - run the command '(admin) install operation 12 attach synchronous' and then
Info: answer the query.
Rolling Back to a Previous Software Set
Cisco IOS XR software allows you to roll back one or more SDRs to a previous committed or uncommitted
software set. Use the show install rollback ? command to view the available rollback points and use the
install rollback to command to roll back the SDR to a previous software set. You can also use the install
rollback to committed command to roll back to the most recent committed software set.
Rollback operations can be performed by running the command in administration EXEC or EXEC mode.Note
Displaying Rollback Points
A rollback point is created every time a software package is activated, deactivated, or committed. Use the
show install rollback ? command to display the eligible rollback points.
RP/0/RSP0/CPU0:router# admin
RP/0/RSP0/CPU0:router(admin)# show install rollback ?
0 ID of the rollback point to show package information for
2 ID of the rollback point to show package information for
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
69
Upgrading and Managing Cisco IOS XR Software
Rolling Back to a Previous Software Set
To Next Page
Loading...
Need help?
General
