Configuration Examples for Implementing SNMP
Configuring SNMPv3: Examples
Setting an Engine ID
This example shows how to set the identification of the local SNMP engine:
snmp-server engineID local 00:00:00:09:00:00:00:a1:61:6c:20:61
After the engine ID has been configured, the SNMP agent restarts.Note
Verifying the Identification of the Local SNMP Engines
This example shows how to verify the identification of the local SNMP engine:
config
show snmp engineid
SNMP engineID 00000009000000a1ffffffff
Creating a View
There are two ways to create a view:
•
You can include the object identifier (OID) of an ASN.1 subtree of a MIB family from a view by using
the included keyword of the snmp-server view command.
•
You can exclude the OID subtree of the ASN.1 subtree of a MIB family from a view by using the
excluded keyword of the snmp-server view command.
This example shows how to create a view that includes the sysName (1.3.6.1.2.1.1.5) object:
config
snmp-server view SNMP_VIEW1 1.3.6.1.2.1.1.5 included
This example shows how to create a view that includes all the OIDs of a system group:
config
snmp-server view SNMP_VIEW1 1.3.6.1.2.1.1 included
This example shows how to create a view that includes all the OIDs under the system group except the sysName
object (1.3.6.1.2.1.1.5), which has been excluded:
config
snmp-server view SNMP_VIEW1 1.3.6.1.2.1.1 included
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
375
Implementing SNMP
Configuration Examples for Implementing SNMP
To Next Page
Loading...
Need help?
General
