DescriptionField
FPD type. Can be one of the following types:
• fabldr—Fabric downloader
• fpga1—Field-programmable gate array
• fpga2—Field-programmable gate array 2
• fpga3—Field-programmable gate array 3
• fpga4—Field-programmable gate array 4
• fpga5—Field-programmable gate array 5
• rommonA—Read-only memory monitor A
• rommon—Read-only memory monitor B
Subtype
FPD instance. The FPD instance uniquely identifies
an FPD and is used by the FPD process to register an
FPD.
Inst
Currently running FPD image version.Current SW Version
Specifies whether an FPD upgrade or downgrade is
required. A downgrade is required in rare cases when
the version of the FPD image has a higher major
revision than the version of the FPD image in the
current Cisco IOS XR software package.
Upg/Dng?
RSP Redundancy and Switchover
This section describes RSP redundancy and switchover commands and issues.
Establishing RSP Redundancy
Your router has two slots for RSPs: RSP0 and RSP1 (see Figure 3: Redundant Set of RSPs Installed in Slots
RSP0 and RSP1 in an 8-Slot Chassis, on page 116). RSP0 is the slot on the left, facing the front of the chassis,
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
115
Managing the Router Hardware
RSP Redundancy and Switchover
To Next Page
Loading...
Need help?
General
