Verifying the Current System Status: Example
The following example shows how to prepare for system verification:
RP/0/RSP0/CPU0:router# show system verify start
Storing initial router status ...
done.
The following example shows output from running the show system verify command.
Although most of the output should display the status “OK,” some processes may show other output, such
as “Warning.” This does not specifically indicate a problem. Contact your Cisco technical support
representative for more information on the output of this command.
Note
RP/0/RSP0/CPU0:router# show system verify
Getting current router status ...
System Verification Report
==========================
- Verifying Memory Usage
- Verified Memory Usage : [OK]
- Verifying CPU Usage
- Verified CPU Usage : [OK]
- Verifying Blocked Processes
- Verified Blocked Processes : [OK]
- Verifying Aborted Processes
- Verified Aborted Processes : [OK]
- Verifying Crashed Processes
- Verified Crashed Processes : [OK]
- Verifying LC Status
- Verified LC Status : [OK]
- Verifying QNET Status
Unable to get current LC status info
- Verified QNET Status : [FAIL]
- Verifying GSP Fabric Status
- Verified GSP Fabric Status : [OK]
- Verifying GSP Ethernet Status
gsp WARNING messages for router
Current set of gsp ping nodes does not match initial set of nodes
- Verified GSP Ethernet Status : [WARNING]
- Verifying POS interface Status
- Verified POS interface Status : [OK]
- Verifying TenGigE interface Status
- Verified TenGigE interface Status : [OK]
- Verifying TCP statistics
- Verified TCP statistics : [OK]
- Verifying UDP statistics
tcp_udp_raw WARNING messages for router
UDP Packets sent has not increased during this period.
- Verified UDP statistics : [WARNING]
- Verifying RAW statistics
- Verified RAW statistics : [OK]
- Verifying RIB Status
- Verified RIB Status : [OK]
- Verifying CEF Status
- Verified CEF Status : [OK]
- Verifying CEF Consistency Status
- Verified CEF Consistency Status : [OK]
- Verifying BGP Status
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
47
Upgrading and Managing Cisco IOS XR Software
Preparing for Software Installation Operations
To Next Page
Loading...
Need help?
General
