Cub Cadet Challenger 550 User Manual

4‐47
Engine
• Place a rag in a vise(2)
• Secure the bearing housing
• Attach the bearing retainer wrench
(3)
• Tighten the bearing retainer
Bearing retainer 110Nm or 81 ft lbs
Install shims so that the tabs are
positioned as shown in illustration.
• Universal joint yoke
• Washer
• Nut(1)
Use the universal joint holder (2) to
hold the yoke.
Universal joint yoke nut
150 Nm or 110 ft lbs
Universal joint
• Install the opposite yoke onto the
universal joint.
• Apply wheel bearing grease to the
bearings
• Install the bearing (1) onto the yoke.
Caution:
Check each bearing. The needles can
easily fall out of the races. Slide the
yoke back and forth on the bearings.
The yoke will not go all the way onto a
bearing if a needle is out of place.
• Press each bearing into the
universal joint using a suitable
socket. Press in far enough for the
cir clip to fit into the groove.
• Install the cir clip (2) into the groove.

Cub Cadet Challenger 550 Specifications

General

Brand	Cub Cadet
Model	Challenger 550
Category	Utility Vehicle
Language	English