General Information
Observe the following when installing
snap rings:
1.
Remove and install snap rings
with snap rings pliers. Refer to
Basic Tools in this chapter.
2.
In some applications. it may be
necessary to replace snap rings
after removing them.
3.
Compress or expand snap
rings only enough to install
them. If overly expanded they
lose their retaining ability.
4.
After installing a snap ring. Make
sure it seats completely
5.
Wear eye protection when
removing and installing snap
rings
E-clips are used when it is not practical
to use a snap ring. Remove E-clips with
a flat blade screwdriver by prying
between the shaft and E-clip. To install
an E-clip, center it over the shaft groove
and push or tap it into place.
Shop Supplies
Lubricants and Fluids
Periodic lubrication help ensure a long
service life for any type of equipment.
Using the correct type of lubricant is as
important as performing the lubrication
service. Although in an emergency the
wrong type is better than not using one.
The following section describes the types
of lubricants most often required. Make
sure to follow the recommendation for
lubricant types.
To Next Page
Loading...
Need help?
General
