Electrical
Checking the Fuses
Note:
Always turn the main switch off when
checking or replacing a fuse.
Set tester to Ohms X 1 position.
If the tester indicates
∞
or OL
replace the
fuse.
Fuses will be found in a distribution
panel located under the hood cover
on the right side of the vehicle.
After testing and replacement of the fuse, turn on the
Main switch to energize and check the circuit that
was affected.
If the fuse blows immediately check the rest of the
circuit for a short.
WARNING:
Never use a fuse with a rating other
than that specified. Never use materials
in place of a fuse. An improper fuse can
cause extensive damage to the
electrical system up to and including a
fire.
To Next Page
Loading...
Need help?
General
