Cub Cadet Challenger 550 User Manual

5‐25
Chassis
5. Install the brake pad (piston side)
(1)(with insulator and pad shim)
• Align the projection (a) on the piston
side of the brake pad with the
groove in the caliper piston.
6. Install the brake pad holding bolts.
17Nm (1.7 m · kg,12 ft ·
lbs) Installing the Rear Brake
Caliper
1. Install the brake caliper with the
mounting bolts.
40Nm (4.0m · kg,29 ft · lbs)
• Brake hose(1)
• Copper washers
• Union bolt(2)
48Nm (4.8m · kg,35 ft · lbs)
2. Tighten the union bolt while holding
the brake hose as shown in this
illustration.
3. Bleed the brake system
4. Check for proper brake fluid level in
the reservoir.
• Above the minimum
level mark
5. Adjust the parking brake cable free
play.

Cub Cadet Challenger 550 Specifications

General

Brand	Cub Cadet
Model	Challenger 550
Category	Utility Vehicle
Language	English