D-Link DSR-500N User Manual

D-Link DSR-Series User Manual 7
Section 3 - Basic Conguration
#3 Congure DHCP Server
1. Log in to the router.
2. Click Network > LAN > LAN Settings. The LAN Settings page will appear.
To change the DHCP settings of the router, follow the steps below:
3. From the DHCP Mode drop-down menu under DHCP Setup, select None (disable), DHCP Server
(enable), or DHCP Relay.
Note: DHCP Relay will allow DHCP clients on the LAN to receive IP address leases and corresponding
information from a DHCP server on a dierent subnet. When LAN clients make a DHCP request it will be
passed along to the server accessible via the Relay Gateway IP address you enter.
4. If enabled, ll in the following elds:
Field Description
Starting IP Address
Enter the starting IP address in the DHCP address pool. Any new DHCP cli-
ent joining the LAN is assigned an IP address within the starting and end-
ing IP address range. Starting and ending IP addresses should be in the
same IP address subnet as the wireless controller’s LAN IP address.
Ending IP Address Enter the ending IP address in the DHCP address pool.
Default Gateway
By default this setting is router’s LAN IP address. It can be customized to any
valid IP within the LAN subnet, in the event that the network’s gateway is not
this router. The DHCP server will give the congured IP address as the Default
Gateway to its DHCP clients.
Domain Name Enter a domain name.
Lease Time Enter the time, in hours, for which IP addresses are leased to clients.
Congure DNS/WINS Toggle to On and enter DNS and/or WINS server IP address(es).
5. Click Save at the bottom of the page.

D-Link DSR-500N Specifications

General

Brand	D-Link
Model	DSR-500N
Category	Network Router
Language	English