D-Link DSR-500N User Manual

D-Link DSR-Series User Manual 226
Section 11 - Troubleshooting
Restoring factory-default conguration settings
To restore factory-default conguration settings, do either of the following:
1. Do you know the account password and IP address?
• If yes, select Maintenance > Firmware & Cong > Soft Reboot and click Default.
• If no, do the following:
On the rear panel of the router, press and hold the Reset button about 10 seconds, until
the test LED lights and then blinks. Release the button and wait for the router to reboot.
2. If the router does not restart automatically; manually restart it to make the default settings eective.
3. After a restore to factory defaults —whether initiated from the conguration interface or the Reset
button — the following settings apply:
• LAN IP address: 192.168.10.1
• Username: admin
• Password: admin
• DHCP server on LAN: enabled
• WAN port conguration: Get conguration via DHCP

D-Link DSR-500N Specifications

General

Brand	D-Link
Model	DSR-500N
Category	Network Router
Language	English