Danfoss VLT AutomationDrive FC 301 Programming Guide

Bit
Description
8
Drive is tripped.
9
Internal CAN error.
10
Wrong configuration data from PLC.
11
Wrong ID sent by PLC.
12
Internal fault occurred.
13
Not configured.
14
Timeout active.
15
Warning 34, Fieldbus Fault is active.
Parameter 9-63 Actual Baud Rate
Table 558: Parameter 9-63 Actual Baud Rate
9-63 Actual Baud Rate
Default value: [255] No baud rate found
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
This parameter shows the actual PROFIBUS baud rate. The PROFIBUS master automatically sets the baud rate.
Option
Name
Description
[0]
9,6 kbit/s
[1]
19,2 kbit/s
[2]
93,75 kbit/s
[3]
187,5 kbit/s
[4]
500 kbit/s
[6]
1500 kbit/s
[7]
3000 kbit/s
[8]
6000 kbit/s
[9]
12000 kbit/s
[10]
31,25 kbit/s
[11]
45,45 kbit/s
[255]*
No baud rate found
Table 559: Parameter 9-64 Device Identification
9-64 Device Identification
Default value: 0
Parameter type: Range, 0 - 0
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation:
AU275636650261en-000101 / 130R0334322 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT AutomationDrive FC 301 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 301
Category	DC Drives
Language	English