Dell PowerConnect W-IAP175P User Manual

6. Click Finish
Figure 118 - Defining Rule — Deny FTP Service Except to a Particular Server
Deny bootp Service except to a Particular Network
1. Click the New link in the Networks tab.
To define the access rule to an existing network, click the network. The edit link appears.
Click the edit link and navigate to the Access tab.
2. In the WLAN Settings tab, enter the appropriate information. and click Next to continue.
3. Use the VLAN tab, to specify how the clients on this network get their IP address and VLAN.
Click Next to continue.
4. Click Next and set appropriate security levels using the slider bar in the Security tab.
5. Click Next. The Access tab appears. The Allow any to all destinations access rule is enabled
by default. This rule allows traffic to all destinations. To define deny bootp service access rule
except to a network:
a. Click New, the New Rule window appears.
b. Select Deny from the Action drop-down list.
c. Select bootp from the Service drop-down list.
d. Select except to a network from the Destination drop-down list.
l Enter the appropriate IP address in the IP text box.
l Enter the appropriate netmask in the Netmask text box.
e. Click OK.
6. Click Finish.
Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide 161 | Instant Firewall

Dell PowerConnect W-IAP175P Specifications

General

Brand	Dell
Model	PowerConnect W-IAP175P
Category	Wireless Access Point
Language	English